Applications
The following pages show a small selection of the many and varied metal spraying applications. You can filter the applications on the left hand side or search for keywords that may relate to your application, e.g. LPG or Steel. Further applications can be seen in the Blog and Press section as well as the Video section.
- General corrosion applications
- Aquatic / Marine / Coastal
- Industrial / Chemical
- Structural / Architectural steelwork
- Tubes and pipes
- Decorative / artistic
- Zinc
- Aluminium
- Non-slip
- General engineering applications
- Reclamation / Repair
- Wear resistant coatings
- Electrical engineering
- Heavy engineering
- Oil and gas
- Architectural / Construction
- Automotive / Transport / Aerospace
- Steel production
- Power generation / Wind Power
- Paper and print
- Other corrosion
- Other engineering
High Velocity Oxygen Fuel (HVOF) coatings HVOF is a high energy thermal spray process which produces dense, strong coatings of cermets and metals which give excellent performance in demanding, aggressive, wear and corrosive environments. HVOF coatings are an important part of advanced surface engineering which enable us to salvage and improve components. This enables machinery […]

Metallisation has launched a new laser cladding system, MET-CLAD, which has further enhanced Metallisation’s diverse range of surface coating equipment. Laser cladding, a process that falls into the range of hard- facing solutions, can be used to increase corrosion resistance, wear resistance or impact performance of metallic components, using a method of applying a fully […]
INTRODUCTION The printing paper and packaging industries use a wide range of rubber coated steel rollers for applying ink, adhesive or the transportation of paper. During use the bearings at each end of the rubber coated rollers will become impregnated with ink adhesive or other types of debris causing them to seize, inducing the roller […]
INTRODUCTION The printing, paper and packaging industries use a wide range of rubber coated steel rollers for applying ink adhesive or the transportation of paper. During use, the bearings at each end of the rubber coated rollers will become impregnated with ink, adhesive or other types of debris causing them to seize, inducing the roller […]
INTRODUCTION In the offset litho printing process, there is a requirement to use a mixture of water and ink to achieve the correct density of print. The introduction of water onto any printing process will inevitably lead to corrosion problems. The blanket cylinder is one of the main casualties of this corrosion, where the […]
INTRODUCTION In the offset litho printing process, there is a requirement to use a mixture of water and ink to achieve the correct density of print. The introduction of water onto any printing process will inevitably cause corrosion problems. One of the main problems on an offset litho press is the plate cylinder, where […]